![]() The boot order from the BIOS or from the virtual machine's settings is not properly set up.You are using a Btrfs filesystem with compression for /boot, for which Syslinux currently cannot boot from.You either need to install or reinstall a boot loader.After it boots, open up a terminal and run: If you do not have a Fallback entry, press Tab (for Syslinux) or e (for GRUB) and rename it initramfs-linux-fallback.img. To do that, you can start the virtual machine using the Fallback entry. Now you need to regenerate your initramfs image. It most likely means that you did not run poweroff like you were instructed to, and closed the virtual machine with the "close" button, which is the equivalent of a power outage. Sh: cannot access tty job control turned off ![]() You are being dropped to a recovery shell ĮRROR: Unable to find root device '/dev/sda1'. "Waiting 10 seconds for device /dev/sda1 ERROR: Unable to find root device '/dev/sda1'" Waiting 10 seconds for device /dev/sda1. This should create device nodes for each partition you have created inside the loop device. # losetup -partscan /dev/loop5 /media/Backup/backup.img Troubleshooting "mount: special device /dev/loop5p1 does not exist" # mv /etc/X11//10-monitor /etc/X11//10-monitor.bakīecause the hardware has changed, while you are still in the chroot, re-generate the initramfs image and do a proper shutdown:įinally, pull out the LiveCD (the ISO file), so that you do not boot back into it, and start the virtual machine. So it is recommended that you move/rename or delete the following: Having an nvidia, nouveau, radeon, intel, etc., entry in the Device section from one of the Xorg configuration files will prevent it from starting, since you will be using emulated hardware (including the video card). dev/sda1 / ext4 defaults,noatime 0 1 Disable any Xorg-related files etc/fstab tmpfs /tmp tmpfs nodev,nosuid 0 0 For now, /dev/sda1 for your entire system is just fine. You may use the UUID or label if you want, but those are more useful in multi-drive, multi-partition configurations (to avoid confusions). Since your entire root tree has been transferred to a single partition, edit the fstab file.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |